June 29, 2020


Page The active sensors and detectors are highlighted. Refer to the adjustment described below. Page 70 1 Pull out the left door. Only off center adjustment is needed for AR-DU3. Paul Please try this web site http: Page Do you want to change the content? Page The Fax mode print density settings for individual Fax modes adjusted through Simulations , , , and are changed to the print density level applied by this simulation.

Uploader: Kazram
Date Added: 26 April 2008
File Size: 16.29 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83323
Price: Free* [*Free Regsitration Required]

Laptops by Dan Ackerman Nov 26, Page Gate operation abnormality remedy operation. Click “Add” to insert your video. This function each fine mode. Screw Rear mounting plate Mounting plate Tray frame Caution: The actual printable area depends on the printer driver to be used.


Page 37 Page 38 – B. Technote troubleshooting Problem Abstract This document contains information on the capabilities that are supported on printer hardware from Sharp.

Adjusted separately for each scan mode. The XL designates wide-carriage printers, the II and III designate upgrades to the Proprinter data stream, and the 24 refers to the Proprinter data stream used for pin printers. You must open the printer as if you were isntalling the print cartridges and remove the packing material from inside the printer.


Error code H Sharp MX – Fixya

The mx3350 factory setting is “AUTO”. Page Operation setting in the auto copy mode 1 Select the number corresponding to the mode with key.

Large, knobby tires, twist grip throttle, hand-operated back brake, and chain-driven motor deliver top-notch performance. Software Operating System Support.

Compatible for Sharp 455 AR351 355 451 Mx350 Mx455 Copier Developer

Page 03 Desk No. It is used primarily in dot matrix line printers, but it is also used in a number of ink jet printers. It rides as well on grass and dirt as it does the street.

Tablets by David Carnoy Dec 13, Paper feed tray lift-up motor Drives the lift plate of the paper feed DC brush motor Selection of Rotation tray. Information on Printers from Sharp. Remove the screw, and remove the front cover right.

Error code H3-01 Sharp MX350 – Sharp MX-3501N All-In-One Printer

Display Display Diagonal Size. Remedy Check CIS unit. To print the manual completely, please, download it. Dot matrix, line matrix, impact, ink jet, and thermal label printers usually support only one printer emulation mode at a time.


When detected except in a job, can be operated in the single surface scan mode. After being scanned, the document discharged to the document exit tray by the paper exit roller. Version-up Procedure 2 Normal mode Write protect mode Version-up procedure 1 Diag mode Write protect cancel Version-up procedure 2 mode Version-up procedure 3 When shipping, the setting of controller write protect bit is cancel mode side.

Login to post Please use English characters only. Mixing roller MX roller Mixes developer carrier and toner and charges toner negatively.

Actual Wiring Chart 2. Check here to start a new keyword search. Most recent reviews Most helpful reviews. Only the set value is changed and no printing is performed.

Paper feed section pickup roller, shrap feed roller, separation pad, separation lower mylar lower: