while the DUT is playing the role of PCE Besides, Spirent TestCenter allows the user to configure or adjust the attributes, e g cost and bandwidth, of. Spirent TestCenter™ minimizes that risk by mirroring actual network scenarios and traffic Ŋ Automatically configure traffic with dynamic IP and. mAc addresses. 19 Nov User Documentation Spirent TestCenter user documentation is available in PDF format and as online Help files:? Documents delivered in PDF.
|Published (Last):||20 July 2013|
|PDF File Size:||17.89 Mb|
|ePub File Size:||20.62 Mb|
|Price:||Free* [*Free Regsitration Required]|
Enable Promiscuous mode when doing multistream at layer 2 testing with T-Rex.
This allows simple function calls, nearly identical to those provided by StcPython. Dictionary with dummy results can be passed by CLI argument —test-params or specified in Parameters section of testcase definition. The following parameters must be set to allow for proper connections to the host with Trex. The below configurations can be adjusted to enable this. This duration should be at least 60 seconds. The stcrestclient package provides the stchttp.
SPIRENT TEST CENTER USER GUIDE PDF DOWNLOAD
The user can also visit www. Please send ‘continuous’ traffic with the following stream config: This feature can be enabled in the configuration files as well as the length of the final verification in seconds. Dummy result pre-configuration 3.
You can also modify the traffic transmission duration and the number of tests run by the gudie generator by extending the example commandline above to:. These parameters applies to all the tests, and are mandatory for all tests. In case of a Dummy traffic generator it is possible to pre-configure the test results.
In spirdnt of burst traffic type, it enables latency measurements for all frames. Dictionary with dummy results can be passed by CLI argument –test-params or specified in Parameters section of testcase definition.
How to Using Routing in Spirent TestCenter – OSPF Example
Metrics collected for supported traffic types 3. This also creates problems when doing multistream at layer 2 since the source macs will be modified. Further information can use obtained from http: If the final verification does not pass the test with the lossrate specified it will continue spirent test center user guide binary search from huide previous point. Xena continuous traffic by default does a 3 second learning preemption to allow the DUT to receive learning packets before a continuous test is performed.
T-Rex API will attempt to retrieve the highest possible speed from the card using internal calls to port information. To get the highest performance and accuracy, Spirent TestCenter hardware is recommended.
T-Rex can have learning packets enabled. For best practice results in deploying STCv, the following is suggested: Content of this folder must be shared e.
It is recommended to verify, that any new file inserted into c: For best practice results in deploying STCv, the following is suggested: Or example of configuration file can be found at location below, but it must be updated manually:.
Continuous Traffic Testing 3. The following parameters must be set to allow for proper connections to the host with Trex.
Test results share 3. The following parameters must be set to allow for proper connections to the host with MoonGen.
Select a version of Spirent TestCenter software to utilize. For best practice results in deploying STCv, the following is suggested:. Connection information for Trex must be supplied inside the custom configuration file.